CraftRecycled products

MULTI-STORAGE BOX

I invite you to a master class made by skilled work fabrication boxes “out of nothing”.

1

Since the three-tier jewelry box, then we need the 3 reels of tape, 4 CD, velvet paper, office and self-adhesive, PVA glue and “Titan”, a thin steel needle and a needle. Jewelry will pick up later.

2

From self-adhesive cut a circle the size of disks. From velvet paper – strips to the inside of the bobbin. Office paper is wrinkled, it will hang end side of the bobbin. Paper can take any, I decided to take a multi-colored.

3

Spokes pierces through the sides of the reels. Layers of cardboard as if pushing the needle and pushes, shaking it while driving.

4

Glue the circles to non-shiny side of the disc. Crumpled paper papered ends. Do not forget about the hole, immediately pierce them.

5

Wallpapers spools on the inner side, glue the circles in the center of the shiny side.

6

Set bobbin center of the disc and the needle mark the point at which the hole is on the disk. holes will not be on the lower disc.

7

Outside, I decided to paste over wallpaper wood bobbins. The upper edge of the bend and glue. A small margin incision 1-1.5 cm and glue the ends of the bobbin.

8

Spokes heated in the flame of a candle and make a hole in it drives in targeted locations. I got to 2-3 hours.

9

Putting design on the needle. Excellent!

10

Glue the spool to the disk glue “Titan”. Try on, you close the needle. The top would also be a good idea to glue anything … First I glued but somehow looked like a child. Replace with our icon

11

We spread our “wealth” and admire the result!

12

Like this…

13

So…

14

This version …

15

Or this …

16

You can open all …

17

Do you still have the CDs? It’s time to make them similar casket!

18

Tags

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Check Also
Close
Back to top button
Close
Close