The mood is good, spring … I decided to try to make Crocus jute.
For the manufacture of Crocus we need:
1) Clay TITAN.
4) Jute beforehand painted in the required color.
5) A sheet of paper on which we will draw a sample of a leaf on which we
drew to spread our leaves of a flower.
6) file which will be held all our work.
On a sheet of paper draw the desired leaf size and we put it in a file drawn two
types of the sheet according to the first sample I made for Crocus boxes.
But as for the flashlight, I have less size, side by side, I drew a smaller,
that’s for him to work and we will.
For the flower, we need two colors, turquoise on the flower itself and orange on the stamens.
Apply glue TITAN on file along with the contour of our sample leaves.
Jute impregnates a little glue to remove lint on splits.
Then spread glue on jute received a contour equal, then cut the twine from the
And so row by row.
Smear glue, impose jute crop, helping tweezers for dense packing twine.
Row upon row
And another row
Well, our leaf is ready! )))
We continue further we have to these three.
hen I pulled a sheet of paper from the file that the sample was close to the finished sheet, and continue
to spread a new leaf.
While the first dries we are working on the second))))
The second piece of paper ready.
All are doing well, pulling a piece of paper from a file and continue to spread
our third sheet of paper.)
Row upon row
Well …. all three leaves we are ready
As long as the leaves dry up, we start to do the stamens.
Cut off three of the same length of 4-5 cm
Fold the end of the splits and prikleevaem making it no matter how big the loop.
We stick together.
And we continue to form a flower.
Floret our ready.
Next, do the green leaves as a weed.
Apply glue along the entire length of the file.
Glue the twine in two lines.
used two shades of color in the work.
Once dried jute cut into the desired length to us
Billets are ready will be used to design a lantern.
Lantern with crocuses in finished form.
Casket with crocuses