This lamp with a colored film of turning inward. So, take twine rope and glue “Titan”, for this you can use any transparent adhesive for soft surfaces. To get started on the paper draw a pattern that will subsequently spread. In this case, the pattern appears to leaves, it can be butterflies or flowers, faces, and even entire stories . On top of the paper, we place the glass and spread twine strings in drawing. All joints and connections of threads sizing. The edges of the strands are arranged so that there are no visible joints and gaps, otherwise, they will be visible glue and beauty will not work. Then the author of the unilateral adorned with beads, which were glued. Once work is completed, lift the work and attach to the glass or just bring to a light, so will be visible to all, badly stapled joints. For this lamp took five sides. When they are ready, it’s time to start making a skeleton. The base frame is made from a wire, after which the paper is wound. And after a string. Putting all the pieces.
Then glue the finished frame each side of the future lamp.
The same principle is doing the bottom and the lid. Strengthen the foundation for LEDs. Do not forget that the LEDs will be introduced through the lower bottom. This will be the top cover. This is the bottom. As seen from the photo, the lower lid more tightly braided cord, in contrast to the top cover. Here is the cover to the light, visible glue, and a single lumen at the joints, as it should be. We finish the assembly of parts and summing LEDs. Lamp ready, by the way, the same can be done and a candlestick .